We supply prefinished building materials direct to builders, architects and construction projects across Australia. Source your timber, fibre cement and plywood through us, or send us your own — either way it leaves our Carole Park facility coated, packed and ready to install.
Save time. Control quality. Build smarter.
Coated, cut, packed and delivered in one run. No site painting, no weather delays.
One supplier instead of three. Less double handling, less waste, less rework on site.
Factory controlled application, tested against paint manufacturer specification on every batch.
Timber, fibre cement and plywood supplied factory finished and ready for installation. Browse the full range and select your profile, finish and quantity. Delivered direct to site.
Send us your own materials for factory coating. We apply the coating, prepare the product and return it finished, packed and ready for your customer.
We are the only accredited Fireshield applicator in Queensland. Factory applied Group 1 fire retardant coating for timber, meeting compliance requirements before the product reaches site.
We run nine fully automated coating lines from our Carole Park facility in Queensland, across timber profiles, flat sheet and panel products. Every substrate is processed in a controlled factory environment, tested against paint manufacturer specifications and finished to the same standard across every run.
Built for volume, consistency and repeatable output at scale.
We are based in Carole Park, Queensland. Yes, products can be delivered to construction sites and supply partners nationally.
Yes. Manufacturers, distributors and builders can supply their own substrate and we will apply factory coating systems to specification. Timber, fibre cement, plywood and aluminium are all accepted.
Yes. We coat everything required to complete a full cladding system. Nails, screws, aluminium angles, plastic trims and other accessories can all be finished to match the primary product, so everything that goes on the wall is consistent from the cladding to the last fixing.
Water based, oil based, solvent based and 2K fluoropolymer. If it goes on timber, fibre cement, plywood or aluminium, we are set up to apply it.
Yes. All factory applied coatings are applied by accredited applicators using approved systems. Warranty terms vary by product and coating system and will be confirmed at the time of order.
Get in touch with your requirements and we will respond within one business day. Provide profile, quantity in lineal metres or square metres, desired finish and colour, and whether you are supplying timber or would like us to source it. We return quotes fast so you can keep your project moving.
Lead times depend on the process. Pre-oiling is generally 3 to 5 days. Vacuum coated finishes are 10 to 14 days. Custom 2K panel finishes are 14 to 21 days. As a rule, allow a minimum of 14 days from receipt of goods. Lead times may extend during peak periods.
Minimum order quantities vary by service:
Orders under a set amount are subject to a $120 setup fee.
Yes, we can match custom colours on certain products. We use an in-house spectrometer and colour matching process, which takes up to 14 days. A physical sample is required and must be signed off by you before we procure any material.
Send us your specification, quantities and delivery location. We will come back with pricing and lead times.
