QC Architectural supplies prefinished building materials direct to builders, architects and construction projects across Australia. Every product leaves the facility factory coated, warranted and ready to install – no onsite finishing required.
Browse the range below and enquire directly through each product page.
Prefinished means the coating is applied before the material reaches site. Done in a controlled factory environment using accredited coating systems, every board or sheet is finished to specification before it leaves the facility.
For builders and architects, that means no waiting on painters, no weather delays and no inconsistent results between batches. Materials arrive ready to fix, with warranties backed by accredited coating partnerships.
We are based in Carole Park, Queensland. Yes, products can be delivered to construction sites and supply partners nationally.
Yes. Manufacturers, distributors and builders can supply their own substrate and we will apply factory coating systems to specification. Timber, fibre cement, plywood and aluminium are all accepted.
Yes. We coat everything required to complete a full cladding system. Nails, screws, aluminium angles, plastic trims and other accessories can all be finished to match the primary product, so everything that goes on the wall is consistent from the cladding to the last fixing.
Water based, oil based, solvent based and 2K fluoropolymer. If it goes on timber, fibre cement, plywood or aluminium, we are set up to apply it.
Yes. All factory applied coatings are applied by accredited applicators using approved systems. Warranty terms vary by product and coating system and will be confirmed at the time of order.
Get in touch with your requirements and we will respond within one business day. Provide profile, quantity in lineal metres or square metres, desired finish and colour, and whether you are supplying timber or would like us to source it. We return quotes fast so you can keep your project moving.
Lead times depend on the process. Pre-oiling is generally 3 to 5 days. Vacuum coated finishes are 10 to 14 days. Custom 2K panel finishes are 14 to 21 days. As a rule, allow a minimum of 14 days from receipt of goods. Lead times may extend during peak periods.
Minimum order quantities vary by service:
Orders under a set amount are subject to a $120 setup fee.
Yes, we can match custom colours on certain products. We use an in-house spectrometer and colour matching process, which takes up to 14 days. A physical sample is required and must be signed off by you before we procure any material.
Send us your specification, quantities and delivery location. We will come back with pricing and lead times.
